Thoughtful delivery service

Easy 30 day returns

Certified Reviews

Description

PSD PhotoSensor (D-Type)IF YOU ARE ORDERING A NEW ADOR, THEN THIS IS THE ONE FOR THE ADOR ELECTRONICS MANUFACTURED AFTER MAY 2015. The ADOR has an integral built in photosensor, so normally, you do not need this external sensor. But if you mount the ADOR inside a dark coop, the external photosensor is needed. It plugs into the ADOR's electronic board and the wire should be run over to the exterior wall of the coop where it can "see" ambient daylight. Often, if installing the

it may be better to use these clips than to try to bend the frame straight

obstruction

check to see that both upper and lower magnets are in place in the right margin of the sliding door panel

or on Amazon

If you have a house power receptacle "110V" or some people say "120VAC" receptacle at or in the coop

The electronics is custom designed using the latest technology

The functions are all embedded in a computer chip on the board and is software-upgradeable

Just remove the sprocket and re-clinch the divots with a hammer and center-punch or big nail

or yard lights

In other words: 15-3/4" wide x 7

low battery warning

Same warranty as new ADOR2