Fork Damper Rod Holding Tool 10.3mm and 12.7mm Engine Build Tools

Fork Damper Rod Holding Tool 10.3mm and 12.7mm Engine Build ToolsThis holding tool is used in conjunction with a fork spring compressor Designed to slide in under the damper rod nut to hold the spring down to allow the nut and fork cap to be separated Double ended 10. 3mm & 12. 7mm Used to assist in fork service and repair Use in accordance with the fork manufacturers instructions

CR500 '97-'01

For assembly and disassembly of dampers in telescopic forks

Without the proper tool it's so easy to mark the stanchions

so that the bottom bolt can be undone

Professional 150mm diagonal side cutters with ergonomic grip with 1000volt protection

a useful wire brush and an uber useful thread pitch gauge

which makes life easy when dragging it out from some low to the ground cruiser

hardened carbon steel bearing/gear grips in the size ranges of 30-50mm and 50 - 75mm with a hardened

1off JIS No 1 75mm shaft

A bit of thin

- Units: Nm

The product below was fantastic compared with screwdrivers etc - but this set is another ball game