86 / GR86 / BRZ WELD IN FRONT SUBFRAME HIGH CLEARANCE KIT new

86 / GR86 / BRZ WELD IN FRONT SUBFRAME HIGH CLEARANCE KIT newWhen installing an offset rack spacer on a 86 BRZ it is necessary to notch (aka cut) a section of the front subframe out for clearance. To make this process easier, we have made this weld in kit. DIY assembly guide provided Laser cut from 2. 0mm steel

NOTE: OEM (cruise control / Radio) buttons not included

974 kg BEARING MATERIAL BEARING MATERIAL STEEL STEEL LUBRICATION LUBRICATION PTFE lined PTFE lined

NOTE: Will only fit RHD Vehicles and LHD 200SX (European delivered)

With an impressive adjustment range of -22mm to +30mmFor more information: 370Z/G37 REAR TOE ARMS (BUCKETS)

NOTE: Can NOT be installed on cars with ABS still fitted however can be used in conjunction with our ABS delete kit as seen under:

5" race style spring to ensure compatibility and ease of spring rate adjustment

NOTE: We do not recommend using any hydraulic handbrake to hold the vehicle after long periods of time

Simply remove your OEM inner HICAS tie rods

The GKTECH Z33 350Z/V35/Z34 370z -6an fuel port adapter is a direct fit for 2003+ Nissan fuel rails

We do have AT mounts however we cannot confirm fitment of the AT Tunnel mounts to V35/G35

We've designed a tapered spacer to allow more air to the front cylinders which results in an improvement in both mid range torque and in top end power

ABS SENSOR BRACKET