Manual Melt Flow Tester - Performs ASTM D1238 and ISO 1133 Procedure A plastics impact

Manual Melt Flow Tester - Performs ASTM D1238 and ISO 1133 Procedure A plastics impactDead weight piston plastometer for procedure A manual operation: calculating flow rate (melt index) for each cut off Three zone precision proportional, integral and derivative (PID) controlled band heater assuring variations of less than + 0. 25C along test area. Built in temperature sensor failure Up to 450C displayed to 0. 1 C Touch screen display with operator driven prompts to easily configure test programs, run tests, and view results Timing

P/N: 02001271

Manually cut the extrudate at the bottom of the orifice with this u-shaped tool

Standards: ASTM D6110

Preprogram the starting positions and piston travel distances for up to ten “time vs

P/N: 02002145

Place this stainless steel weight on top of your MFI and use along with piston rod to obtain a test load of 10000 grams or 10 kg

and Volume Rate

P/N: 12002031

Place this aluminum weight on top of your MFI and use along with piston rod to obtain a test load of 500 grams or 0

Three-zone precision proportional

Standards: ISO 1133

Use this brass cleaning brush to clear residual material out of the standard die